Wyco 933 Concrete Vibrator

Description

Build one concrete house with this Vibrator. Make an offer on this idem!
Wyco High Cycle Vibrators are manufactured to properly consolidate difficult performance-based concrete mix designs.
The Wyco 993 Electric Flex Shaft Vibrator is designed to work well in medium-to-high slump applications such as vibration of concrete for driveways, foundations, walls, columns, and small slab work. Lightweight and rugged, these vibrators feature double insulated and grounded electric motors. They feature a dust and waterproof on-off switch. The consistent speed output, under variable loads, produces uniform results. High frequency and amplitude of the vibrator head ensures more complete consolidation of concrete. The unique Squarehead™ design ensures that your job will have the quality and production you have come to expect from Wyco.
There are 2 extension flex shafts, a 5 foot and a 7 foot with a shaft coupler.
A new Vibrator of that dimension would cost over 00.-.
There is damage to the 20 foot flex shaft that is fixed. Two ¼ inch holes on the rubber wall from a rodent, 1 foot and 3 foot from the vibrator head - does not impact the Vibrator or the shaft at all. This Concrete Vibrator was purchased from the Owner builder to build one concrete home and it’s not needed anymore. The unit is always stored indoors.
Vibrator Head
•
Allows for better control and prevents head trapping
•
Fine threads assure a tight sealed connection
•
One of the strongest vibrator shafts in the industry
•
Shipping weight (Shaft, Head, Motor) 55 LB
FEATURES
Lightweight, but rugged unit preferred by operators
Double insulated and grounded motor improves safety
Air filters extend motor life and allow for easier maintenance
High frequency and amplitude of the vibrator head on the Head, Motor, Shaft System ensures more complete consolidation of concrete
Motor airflow from rear to front prevents dust buildup that would otherwise cause motor damage
Dust and waterproof on-off switch eliminates burnout and damage
Strain relieved electrical cord inhibits cord pull out, reducing downtime
Standard 120 Volts, 60 Hz electrical power
Four head bearings lubricated with high temperature resistant synthetic oil, prevent bearing failure due to inadvertent operation of equipment out of concrete
Hardened head housing and tip prolongs head life and increases productivity
Oil resistant reinforced rubber shafts with steel reinforced coils on the disconnect end reduces wear and increases shaft life
TECHNICAL FEATURES
Double insulated universal motor
Vibrator Type
Internal Concrete
Power Source
Electric
Voltage
115VAC
Phase
1
Amps
15
HP
3
Force Rating
1150 to 2500 lb.
Force
Centrifugal
Duty
Intermittent
Bin Weight Capacity
100 lb.
Speed
10,500 vpm
dBA
98
Max. Cubic Yards per Hour
20
Max. Temp.
105 Degrees F
Head Size
2 3/8" x 12 ½ inch long
Shaft Length
20 ft., 5 ft. and 7 ft. with shaft coupler
Mounting Position
Horizontal
Mounting Plate
No
Enclosure
Totally Enclosed
Housing Material
Plastic
End Bell Material
Steel
Bearing Type
Sealed Ball
Application
Concrete Consolidation
Standards
UL Listed
Radial fan motor runs cooler, lasts longer
Heavy duty protective frame